Commands Via Sms - Siemens TEL50.GSM General Instructions Manual

When the "#" tone is received, if the command is effected, the sequence of corresponding beeps (ON or OFF) is generated. If
the command is not recognized or is not applicable (for example, if an ON command is sent to an input "31#"), the ERROR tone
is generated. If the " " tone is received, the OFF tone is generated as confirmation of the command.
‫٭‬
Call the telephone number for the TEL50.GSM and wait for the device to answer (a beep after the first ring).
Dial the command you require from those available (see table).
Command Reply
41# beep-beep
51# beep-beep
40# beep
50# beep
42# beep-beep (contact closed) – beep (contact open)
52# beep-beep (contact closed) – beep (contact open)
32# beep-beep (contact closed) – beep (contact open)
62# beep-beep (temp. alarm active) – beep (temp. alarm not active)

6.2 Commands via SMS

Commands and queries via SMS must be sent to the TEL50.GSM with the following syntax:
- all letters must be uppercase
- no spaces at top or bottom of message. Observe spacing as indicated.
An unexpected command, for example IN1=1 (an input cannot be enabled), or with incorrect syntax (for example, use of
lowercase characters) or in any case not recognized by the apparatus, produces a reply SMS with message "ERROR xx" (see
par.9 "Error signalling". Make sure that the source number is in the USER list (see par. 7.1) or, if it is not, that the incoming call
control is not enabled (SECURITY=0 factory disabled).
Building Technologies
Action
closes contact relay 1 (eg. boiler start-up)
closes contact relay 2 (eg. irrigation enabled)
opens contact relay 1 (eg. boiler shut-down)
opens contact relay 2 (eg. irrigation stopped)
queries the status of contact relay 1
queries the status of contact relay 2
queries the status of alarm input
queries the status of temperature alarm
- 16 - TEL50.GSM