Siemens TEL50.GSM General Instructions Manual page 21

[USER] command examples
SMS command
USER USER01=3351234567.1
USER USER02=3471234567.2
USER USER03=3291234567.3
USER USER20=3201234567
USER USER01
USER USER05
USER USER01=
USER 3351234567=
The USER numbers entered without extension assume the Notify User (extension.3) default value. There is no limit to the
number of users for each profile. In this section there is a SECURITY parameters that enables control of the incoming call
numbers. When this parameter is enabled (SECURITY=1), only the users in the USER list can interact with the device
according to their profile (administrator, user, notify). A voice call or an SMS message from a number that is not on the USER
list will not receive a reply. The SMS number must be exactly the same as the configured SMS or it will not be recognized.
When the list is empty, in case of activation SECURITY=1, the number used to send this SMS will automatically be inserted as
administrator even in case it has been inserted as user or notify.
[USER]
SMS command
USER SECURITY=0
USER SECURITY=1
USER SECURITY
Building Technologies
SMS reply
USER01=3351234567.1
USER02=3471234567.2
USER03=3291234567.3
USER20=3201234567
USER01=3351234567.1
USER05 deleted
USER01 deleted
USERxx deleted
SMS reply
SECURITY=0
SECURITY=1
SECURITY=0 or SECURITY=1
Action
User USER01 set as Administrator
User USER02 set as User
User USER03 set as Notify
User 20 set as Notify
queries USER01 position
queries USER05 position (no number present)
cancels USER01 position
cancels the User number 3351234567 from position xx
Action
Incoming calls filter disabled
Incoming calls filter enabled
queries status of SECURITY variable
- 19 - TEL50.GSM