Initial System Test Set-Up - Mercury Installation And User Manual

Initial system test set-up using Mercury
See diagram on page 5
• Connect the supplied CAT5 cable to the audio system through control plate 1 port. Then connect the CAT5
cable to the wall plate.
• Set the dip switch on the back of the plate to zone 1.
• Connect 1 speaker into the zone 1 speaker outputs.
• Connect the supplied 3.5mm jack to RCA cable to audio source 4 and connect any portable audio source
(mp3 player or smart phone are ideal).
• Connect power supply lead to audio system.
• Turn the system on at the main switch by the power lead terminal.
• Using the connected control plate press 'source 4'
• You should now hear the music from your connected device being played though the speaker.
Trouble shooting
If you don't hear the connected audio source:
• Ensure the volume is tuned up on the control plate
• Ensure the volume is tuned up on the Source device
• Check ALL connections. Ensure the source device is connected to 'Source 4' and 'Source 4' is
selected on your control plate.
This initial set up is a simple, quick, and reliable way to set up your Mercury Multi-Room Audio System. It is also
a good way of testing any connection or multiple accessories for larger installations. The system is designed to be
adaptable and can be expanded once a basic installation is up and running.
Issue Date: June 2014
control plates
®
i - MRA - User Manual REV_ E&OE E
4