Mercury Installation And User Manual page 12

Mounting and Installing the Mercury
The System is designed to hang vertically and is supplied with a fixing kit and template showing the required position
for the screws. (124mm apart and 54mm below where the top of the system will sit.)
Issue Date: June 2014
Hub
®
1) Using the fixing kit provided and installation template
mark the 3 required screw holes positions ensuring the
system is square. Leave a gap of at least 30mm at the
top and enough room around the system for adequate
ventilation.
2. Drill the 3 holes with 6mm masonry drill bit.
3. Insert 6mm brown raw plugs.
4. Screw top 2x M8 40mm dome head screws supplied
in fixing kit into raw plugs with Philips screwdriver
leaving between 5mm and no more than 10mm of the
screw protruding the wall surface as not to damage
internal components.
5. Remove system from box and packaging
i - MRA - User Manual REV_E E&OE
12