Site Preparation; Package Contents - Foundry Networks ServerIron 4G-SSL User Manual

you can remove one of the supplies without interrupting operation. The remaining supply provides enough power
for all the ports.
The RPS5 power supply is 100VAC @ 3.5A, 240VAC @ 1.5A, 50-60Hz, auto-sensing, and auto-switching. The
RPS5DC is a 36-72 VDC power supply.
Figure 4.5 on page 4-5 shows a rear view of a ServerIron 4G containing one RPS5 power supply.
Figure 4.5 RPS5 Power Supply
Figure 4.6 on page 4-5 shows a rear view of a ServerIron 4G containing one RPS5DC power supply.
Figure 4.6 RPS5DC power supply
Installing ServerIron 4G Series
WARNING: The procedures in this manual are for qualified service personnel.
This section contains describes how to install the ServerIron 4G series devices.

Site Preparation

This section describes the procedures required to prepare the site for installatoin.
Cabling Infrastructure
Ensure that the proper cabling is installed in the site. See "Technical Specifications" on page 4-21 or
www.foundrynetworks.com for a summary of supported cabling types and their specifications.
Installation Location
Before installing the device, prepare its location and orientation relative to other devices and equipment. Allow at
least 3" of space at the front of the device for the twisted-pair, fiber-optic, and power cabling. Also, allow a
minimum of 3" of space between the sides and the back of the device and walls or other obstructions.

Package Contents

The ServerIron 4G Series systems ship with the following items. Review the list below and verify the contents. If
any items are missing, contact the place of purchase.
• Foundry Networks ServerIron 4G or ServerIron 4G-SSL device
• 115V AC power cable (for AC sourced devices)
October 2008
Plastic Latch
© 2008 Foundry Networks, Inc.
ServerIron 4G Series
AC Power
Connector
Power Supply (standard)
4 - 5