Foundry Networks ServerIron 4G-SSL User Manual page 18

Foundry ServerIron Hardware Installation Guide
NOTE: If you address the ping to the IP broadcast address, the device lists the first four responses to the ping.
Observing LEDs
After you install the network cables, you can observe certain LEDs to determine if the network connections are
functioning properly. Table 4.1 outlines the LEDs related to the network connections, the desired state of each
LED, possible abnormal states of each LED, and what to do if an LED indicates an abnormal state.
LED Desired
State
Link (Lnk) On
(Green)
Active (Act) On or
blinking
(Green)
If a problem persists after taking these actions, contact Foundry Technical Support.
4 - 18
Table 4.1: Network Connection-Related LED States
Meaning Abnormal
State
A link is established Off
with the remote port.
The port is Off for an
transmitting and extended
receiving user period.
packets.
© 2008 Foundry Networks, Inc.
Meaning/Action
A link is not established with the remote port.
You can do the following:
• Verify that the connection to the other
network device has been properly made.
Also, make certain that the other network
device is powered on and operating
correctly.
• Verify that the transmit port on the
Foundry device is connected to the
receive port on the other network device,
and that the receive port on the Foundry
device is connected to the transmit port
on the other network device. If you are not
certain, remove the two cable connectors
from the port connector and reinsert them
in the port connector, reversing their
order.
• Dust may have accumulated in the cable
connector or port connector. For
information about cleaning the
connectors, see "Cleaning the Fiber-Optic
Connectors" on page 4-17.
• If the other actions don't resolve the
problem, try using a different port or a
different cable.
The port is not transmitting or receiving user
packets. You can do the following:
• Check the Link LED to make sure the link
is still established with the remote port. If
not, take the actions described in the
Meaning/Action column for the Link LED.
• Verify that the port has not been disabled
through a configuration change. You can
use the CLI. If you have configured an IP
address on the device, you also can use
the Web management interface or
IronView.
October 2008