Installing The Mx101 On The Customer's Right Side (Default) Of The Tower Cover - Motorola MP6000 Integrator Manual

Installing the MX101 on the Customer's Right Side (Default) of the Tower Cover

To install the MX101 on the customer's right side (default) of the MP6000:
Remove the MP6000 tower bezel by squeezing inward on both the left and right sides of the lower part of
1.
the tower bezel, pushing its side snaps to disengage. Slide the tower bezel up and lift out.
Squeeze
Inward
Removing the MP6000 Tower Bezel
Figure 3-15
Remove the MP6000 rear tower cover by gently pulling outwards on the tabs on either side; then slide the
2.
tower cover back to remove.
Tab(s)
(on each
side)
Removing the MP6000 Tower Cover
Figure 3-16
Determine the side of the MP6000 to which the MX101 should be installed. The default is the customer's
3.
right side (the side of the MX101 tower cover already open for the scan module to be inserted).
NOTE See Installing the MX101 on the Customer's Left Side of the Tower Cover on page 3-21
module on the customer's left side of the tower cover.
SITE PREPARATION AND INSTALLATION 3 - 17
Tower Bezel
to install the scan