Motorola MP6000 Integrator Manual page 145

LEDs, and Beeper Sequences (Continued)
Table 4-6
7-segment
Scale State
Diagnostic Display
Successfully Step 2 - Program
entering scale Legal Parameters
legal Calibration and Step 3 -
Mode Calibration at NO
LOAD
C00Lb
depending on units
programmed as
pounds (lb) or
kilograms (kg)
Step 4 - Calibration
at LOAD
C25Lb
depending on units
programmed as
pounds (lb) or
kilograms (kg)
Step 5 - Calibration
Success or Failure
Repeat scrolls of
CALP
Any step - Calibration
Fails - Scrolls fault
code:
Between No change
calibration steps
No platter No change
installed at Step
3 - Calibration at
NO LOAD
Stepping through No change
a calibration step
Failure to place C25Lb
the correct load
depending on units
on the scale at
programmed
Step 4 -
Calibration at
LOAD
LED
(System)
No change
- Scrolls
C00g
OR
- Scrolls
C11g
or
-
CALS
then
u##
No change
No change
No change
C11g No change
or
SCALE CALIBRATION (MODELS WITH A SCALE ONLY) 4 - 21
Beeper
Sequence
Five long beep
tones
No change
Persistent short
beep tone at
1Hz
Single long
beep tone after
pressing the
Scale Zero
button
Two long beep
tones
Scale
Zero
Optional Scale Display
Button
(LED)
Off Step 3 - Calibration at NO
LOAD
Blinks between CAL00 and
then CAL_ _ with correct
unit icon illuminated (lb or
kg).
Step 4 - Calibration at
LOAD
Blinks CAL25 with lb icon
illuminated, or blinks
CAL11 with kg icon
illuminated.
Step 5 - Calibration
Success or Failure
Blinks between CAL P
(PASS) and CAL S (save
legal parameter settings).
Any step - Calibration fails
blinks CAL F.
Off Blinks HOLD while taking a
measurement.
No change Blinks PLA
Off No change
No change No change