Sony LMD-2451MT Instructions For Use Manual page 12

multi-signal formats, including 1080P, 1080i, 1080PsF
and 720P, are available, line-by-line typed DVI signals
are also supported.
Checkerboard
Left and right HD-SDI input signals are displayed in a
grid pattern. The two signals shown in a grid makes for
easy adjusting of the iris and color settings for the
camera. This function is only available in 2D display
mode.
L/R switch
Left and right dual-stream HD-SDI signals can be
swapped over without being visually disturbed by black
frames. This allows you to easily compare the color and
brightness between left and right signals. This function
is only available in 2D display mode.
Disparity simulation
The phase of either or both left and right signal for 3D
image can shift horizontally. The monitor simulates
parallax without the need for 3D rig adjustment. It saves
time and effort in setting and adjusting the 3D rig and
equipment.
Note
Simulated images cannot be output to any device.
Horopter check
Left/right signals for the 3D image are displayed in
selected single colors. This helps you define if the
subjects are in front of the determined screen position or
behind it. You can carefully adjust the depth of the 3D
effect using this feature. This function is only available
in 3D display mode.
Flip H
If a half mirror type rig is used, left or right signal will
be reversed. With the Flip H feature, signals that are shot
this way are horizontally reversed again for normal
viewing.
Note
A delay between left and right signals occurs as a result
of the signal processing. Because left and right signals
are internally synchronized to offset the delay, display
speed may decrease before the image reaches the screen.
Payload ID
Channel assign information of payload ID data
superimposed on input signals is displayed. You can
monitor which of two channels a left/right input signal
is assigned to.
12
Features
Picture
Fully digital 10-bit signal processing circuit
As well as digital signals, all signals including analog
signals are converted into digital signals. All signals are
processed using a fully digital 10-bit processing circuit
so that an image is produced in smooth gradation
without any deterioration of quality.
Auto chroma/phase function
The chroma and phase of the decoder are automatically
adjusted.
High image-quality/high-resolution WUXGA
LCD panel
An WUXGA high-resolution (1,920 × 1,200 dots) panel
and high brightness/ultra-wide field of view technology
enable you to use the monitor under various lighting
conditions and in numerous ways (installing on wall,
using several monitors to view an image, and so on.).
Because a color filter with wide-color reproduction and
LCD materials with high response speed are used, the
motion picture of the video signal is displayed clearer.
This monitor also performs sampling of signals at high
frequencies and provides a high resolution of 700 TV
scanning lines or more during the RGB or component
signal (480/60I, 575/50I) input.
Input
Accepts analog RGB input signals
Adopting the scan converter allows this monitor to
detect VGA, SVGA, XGA and SXGA analog RGB
signals input to the HD15 input connector.
For more information, see "About the preset signal" on
page 44.
Accepts DVI-D (digital) input signals
Adopting the scan converter allows this monitor to
detect VGA, SVGA, XGA and SXGA digital computer
signals input to the DVI input connector.
The number of the DVI input connectors can be
increased by installing the optional input adaptor into
the optional input slot.
To view more than SXGA signals when the DVI input is
selected, use the cable within 3 m (118
length.
For more information, see "About the preset signal" on
page 44.
Optional slot
Two optional input adaptors can be installed. The
composite, Y/C, component, analog RGB, SDI or DVI-
D signal can be input depending on the input connectors
of the board to be used.
1
inches) in
/8