First Alert FA2100C User Manual page 10

Quick Arming
mi
To Assign, Change,
or Delete
User Codes
REMOTE KEYPAD USER CODES
If your system supports "Quick Arming", the "#" key can be pressed in place of
the user code when arming the burglary protection. The user code is always
required, however, when disarming.
User Number 2 can change, but not delete, his/her own code and can assign,
change, or delete codes for User Numbers 3-8
User Numbers 3-8 cannot assign, change, or delete user codes.
1. Enter the User Number 2 code and press the CODE key.
2. Enter a single-digit User Number (2-8) for the user whose code is to be
assigned, changed, or deleted. Note: The Duress code corresponds to User
Number 8.
3. /f assigning or changing a user's code, enter the new 4-digit code for that
user. The keypad will beep once, indicating that the new code has been
accepted.
If deleting a user's code, perform steps 1 and 2 and then stop. After a few
moments the keypad will beep once, indicating that the existing code has been
deleted.
-1 o-