Marquis Spa Control Operation - Marquis E-series Owner's Manual

marquis s p a c o nt r o l o p e r a t i o n
9-Button: Show
8-Button: Epic, Euphoria, Promise 2P, Resort,
Reward, Wish
7-Button: Spirit, Mirage, Promise 1P, Rendezvous
PUMP PRIMING (Pr)
Pump priming feature begins at startup. When your spa
is energized, the LCD window displays a "Pr" message.
This mode lasts approximately four to five minutes if not
exited manually by pressing the TEMP+ pad.
Your hot tub has been configured at the factory to run
without any additional programming changes other than
setting the desired temperature. We do however rec-
ommend that the time is set as this will be shown in the
display as a convenience and aids in controlling when
the hot tub will filter. See "changing the system settings"
below on setting the time.
The hot tub controls are state of the art and will retain all
of the settings or changes that have been made in the
event of a power failure.
CoNtRol PaNEl oPERatIoN INStRUCtIoNS
Hot kEyS
Using pump 1:
Pressing the Jets 1 button will turn pump 1 on low
speed. Pressing a second time will turn the pump on
high speed. Pressing the button a third time will turn the
pump off. The pump will run for 15 minutes before shut-
ting off or switching to low speed. If the pump continues
to run on low speed after the 15 minute timeout, the
system is either calling for heat or has entered into a
filtration cycle.
39