Marquis E-series Owner's Manual page 44

marquis s p a c o nt r o l o p e r a t i o n
oPtIoNal CoNtRolS
auxiliary jet buttons: (if equipped)
Depending on the model of hot tub, there are may
be up to two auxiliary jet controls for operating the jet
pumps. Pressing the Jets button will turn pump on
low speed. Pressing a second time will turn the pump
on high speed. Pressing the button a third time will
turn the pump off. The pump will run for 15 minutes
before shutting off or switching to low speed.
Wi-Fi control: (if equipped)
Your hot tub is configured with a special component
that will allow wireless control with most Apple based
products such the Ipod Touch, Ipad and Iphone. This
is an exciting feature that allows wireless operation of
the spa functions and most settings.
Please note that the typical operating range is within
30 feet of the hot tub depending on obstructions or
location/orientation. The signal may not be strong
enough in some cases to adequately establish and
hold communication between the hot tub and your
device especially when operating from indoors and
the signal has to travel through walls. Keep this in
mind when placing your hot tub during installation in
an effort to keep any obstructions to a minimum.
Initial set up:
1. In order to communicate and operate the hot tub,
you will need to go to the App Store and down-
load the free "Marquis Spas & Hot Tubs" app to
your device.
2. Go to the settings section on your Apple device
and choose the "Wi-Fi" tab. Be sure that the
Wi-Fi selection slider is set to the "On" position so
your device will discover all available Wi-Fi choic-
es. Choose the tab labeled BWG followed by a
series of numbers. Be sure your device connects
which should be shown by the presence of a
check mark next to the name.
3. Return to the main screen and open the Marquis
App and proceed to "connect" with the hot tub.
Stopping the connection process and restarting
may be required. There is nothing wrong with the
unit as this can be caused by protocols issued by
Apple Inc.
4. Once connected you will be able to operate the
jets and light on the control tab of the App. Mov-
ing to the settings tab will allow changing the time,
temperature and filtration settings of the hot tub.
Note: If your device goes to sleep, screen darkens,
or is turned off you will need to reconnect again with
the hot tub in order to reestablish control.
44