Marquis E-series Owner's Manual page 14

Vent air by slightly
opening pump unions.
9. At this time the spa should have water flowing
from the jets. If the pump has not primed and the
water is not flowing from the jets after two minutes
TURn OFF POWER TO THE SPA and vent air from
the pumps by slightly opening the pump unions
located behind the equipment door. After turning
the power on again, the spa initiates a new priming
mode. Repeat steps above.
10. The system requires approximately two minutes
of water flow to determine the water temperature.
After two minutes of water flow, the temperature
is displayed as actual water temperature. After you
have manually exited the priming mode (or allowed
the spa to automatically exit) the LCD window mo-
mentarily displays 100°F (38°C) and then the display
switches to - - °F.
11. The factory default setting for water temperature
is 100°F (38°C). Use the TEMP pads on the control
panel to set the water temperature to the desired
level. (See SPA COnTROL OPERATIOn.) It takes up
to 24 hours to heat the water to desired tempera-
ture depending on the water temperature and
voltage of your spa.
12. If water is not coming out of the jets, check to
make sure the adjustable jets are open. Simply turn
the jet face to open or close the jets.
Test the water for the proper chemical balance and
adjust as necessary. SpaCare products are recom-
mended. (See WATER TREATMENT.) PROPER
CHEMICAL bALANCE IS IMPORTANT for your
safety and the longevity of your spa.
s t a rt i ng y o u r s p a
14