Marquis E-series Owner's Manual page 40

marquis s p a co nt ro l o p e r at i o n
Using pump 2 (if equipped):
Pressing the Jets 1 button will turn pump 1 on low
speed. Pressing a second time will turn the pump on
high speed. Pressing the button a third time will turn
the pump off. The pump will run for 15 minutes before
shutting off or switching to low speed.
Using pump 3 (if equipped):
Pressing the Jets 1 button will turn pump 1 on low
speed. Pressing a second time will turn the pump on
high speed. Pressing the button a third time will turn
the pump off. The pump will run for 15 minutes before
shutting off or switching to low speed.
light:
Pressing the light button will turn the LED lights on.
Pressing a second time will turn them off. If left on the
LED lights will automatically turn off after 30 minutes.
Special light feature: You can change the color of
the LED lights by pressing the light button repeatedly
within 3 second intervals. Doing this will allow you to
scroll and choose a specific color or light sequence.
all QUIEt Soak FEatURE
Pressing the soak button activates a special feature
that turns off all pumps and heater allowing for a quite
soak in the hot water. Pressing the button a second
time will restore the unit back to normal operation. If
left on, the soak mode will time out after 15 minutes
and revert back to normal operation.
Note: Periodically the pump/s may continue to oper-
ate for a short time after pressing the soak button.
This typically happens when the spa is in a heat cycle
as the heater will need a short period to cool down
before stopping the water flow.
SEttING tHE tEMPERatURE
Pressing the temp up or temp down buttons allow
you to adjust the heat to the desired temperature.
The set temperature is shown in the left hand side
of the LCD display. Pressing and holding the temp
up or temp down button will allow for an accelerated
change of the temp.
• Factory default temp - 100°F
• Maximum set temperature - 104°F
• Minimum set temperature - 60°F
40