Marquis E-series Owner's Manual page 57

START-Up
FILLING THE HOT TUB
The water level should be filled to 4" (102mm) down from the top of the spa
shell. Fill only with clean water. If your water source contains particles, please
contact your dealer for a fill filter.
pOWERING Up THE SpA
1. After the spa has been filled with water, the power to the hot tub can be
turned on. When the power to the hot tub is turned on, the display on
the control panel will read "RUN PMPS PURG AIR -- -- -- --" . This is an
opportunity to run the pumps and purge any air from the system and
associated plumbing lines. This period will last 4-5 minutes or can be
exited by pressing the Temp +/- button or pump buttons.
2. The hot tub controls are preprogrammed from the factory and will not
require any additional modifications.
OpERATING THE ELECTRONIC CONTROLS
Jets 1
If the jETS 1 pump is off, press jETS 1 button to turn on pump 1 to low
speed. Pressing a second time will turn the pump on to high speed.
Pressing a third time will turn the pump off. The high speed of pump 1 will run
for 15 minutes and then switch to low speed. Once on low speed the pump
will run for 15 minutes and then shut off. To restart the pump, press the
jETS 1 button." The yellow LED indictor under the LCD display will illuminate
anytime the pump is running.
NOTE: If the system is in a filter or heating cycle, low speed will continue to
run.
Jets 2 (Two pump Models Only)
Pump two has only one speed. Press the jETS 2 button to turn on pump
two high speed. Pressing a second time will turn the pump off. The high
speed of pump 2 will run for 15 minutes and then turn off. To restart the
pump, press the jETS 2 button.
e-series spa control operation
57