Motorola AP6562 Installation Manual page 14

Hide thumbs Also See for AP6562:

Table of Contents

11. Verify the unit has power by observing that the LEDs are lit or flashing.

CAUTION

To use the extension arm with the mounting hardware kit:

1. Attach the pole mount section at the desired mounting location using a U-bolt or band clamps.

2. Complete the steps for assembling and positioning the mounting bracket sections for poles less than or

greater than 3 inches (see

3. Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach the extension arm

to the access point bracket section with four M6 hex flange screws. Tighten the hex flange screws to 60

inch pounds (lbf-in).

4. With the access point properly positioned, attach the extension arm to the access point with four M6 hex

flange screws. Tighten the hex flange screws to 60 inch pounds (lbf-in).

5. If required, install and attach a Kensington security cable (customer supplied) to the unit's lock port.

6. Attach an Ethernet cable from the access point to a controller with an 802.3at-compatible power source

oruse the designated outdoor rated power supply (AP-PSBIAS-7161-US or AP-PSBIAS-7161-WW) to

supply power to the AP6562 (once fully cabled).

7. Verify the unit has power by observing that the LEDs are lit or flashing.

CAUTION

If not using a 802.3at capable controller to power the AP6562, ensure

only the AP6562's designated outdoor power supply

(AP-PSBIAS-7161-US or AP-PSBIAS-7161-WW) is used to supply

power to the access point. Using an incorrectly rated power supply

could damage the unit and void the product warranty. Do not actually

connect to the power source until the cabling portion of the

installation is complete.

Vertical Pole Mount on page 12