Firmware Environment Commands - Kyocera FS-C5150DN Service Manual

(3) Firmware environment commands

The printer maintains a number of printing parameters in its memory. There parameters may be changed per-
manently with the FRPO (Firmware RePrOgram) commands.
This section provides information on how to use the FRPO command and its parameters using examples.
Using FRPO commands for reprogramming firmware
The current settings of the FRPO parameters are listed as optional values on the service status page.
Note: Before changing any FRPO parameter, print out a service status page, so you will know the parameter
values before the changes are made. To return FRPO parameters to their factory default values, send the
FRPO INIT (FRPO-INITialize) command.(!R! FRPO INIT; EXIT;)
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to PCL6
!R! FRPO P1, 6; EXIT;
FRPO parameters
Item
Default pattern resolution
Page orientation
Default font No. *
PCL font switch
Total host buffer size
Form feed time-out value
Top margin
Left margin
Page length
Page width
Duplex mode
Sleep timer time-out time
Ecoprint level
FRPO
B8 0: 300 dpi
1: 600 dpi
C1 0: Portrait
1: Landscape
C2 Middle two digits of power-up font
C3 Last two digits of power-up font
C5 First two digits of power-up font
C8 0: HP compatibility mode
32: Conventional compatibility mode
H8 0 to 99 in units of the size defined by FRPO S5
H9 Value in units of 5 seconds (1 to 99)
L1 Top margin (integer value)
L2 Top margin (decimal value)
L3 Left margin (integer value)
L4 Left margin (decimal value)
L5 Page length (integer value)
L6 Page length (decimal value)
L7 Page width (integer value)
L8 Page width (decimal value)
N4 0: Off
1: Long edge binding
2: Short edge binding
N5 Value in units of 1 minute (1 to 240)
N6 0: Off
2: On
2-4-3
Setting values
2KT/2KV
Factory
setting
0
0
0
0
0
0
5
6
0
50
0
50
10
61
8
11
0
15
0