Table of Contents
Advertisement
Page 10
2. Programming the DSS Keys
DSS Keys - Alias:
- Line keys.
- F Keys.
- Repertory dialling.
3. Reassociating a DSS Unit
4. Clearing Settings
INDeX DSS/BLF Guide
You can program each DSS key with a line, extension or group directory
number. Once programmed, the key's BLF lamp displays the status of
that number and call to that number (eg. free, busy, ringing, etc).
Alternatively, you can program a key with a system speed dial store
number.
To program a DSS key:
1. Press PROGRAM and then the DSS key to use.
2. Enter the phone's passcode.
3. The display shows the current stored number (if set).
4. Press CANCEL to clear the stored number.
5. Enter the number to store:
– For an extension, line or group number, simply dial the directory
number to store.
– For a system speed dial number, press the SPEED DIAL key and
dial the required speed dial store number.
6. Select another DSS key or press DONE.
7. Press PROGRAM to finish.
You can change the phone with which the DSS/BLF is associated
without physically moving the unit. This saves having to reprogram the
DSS keys. The associated phone must still be a DT or TT display
phone.
To reassociate a DSS/BLF:
1. Switch off the units power supply.
2. While holding down any two DSS keys in different columns, switch
the unit's power supply back on.
3. The unit should switch back on with the top keys flashing alternate
green and red. Continue from Step 3 of associating a DSS/BLF (see
page 9).
Inserting any other type of phone (even temporarily) into the DSS/BLF's
socket, erases all the DSS/BLF's programming. If the DSS/BLF is
reconnected you must associate it with a DT or TT display phone again
(see "Associating the DSS/BLF" on page 9) and then reprogram the
DSS keys (see above).
38GDE00001SAR - Issue 5 (January 1999)
Advertisement
Table of Contents
