Advertisement
Assemble the lighting
The lamp arms and cross bars should
be assembled as described in the
Assembly Chapter of the main MP 4
instruction manual. The numbers
throughout the text refer to the
illustrations at the end of this booklet.
The lamps should be positioned on
each cross bar in the locations shown
in Illustration 1.
1
Place the power supply next to the
baseboard, so the controls will be
accessible and visible.
2
Loosen the knob on the lamp
mount, and slide the lamp into its
correct location on the cross bar
(2).
3
Loosen the locking lever (3-a) and
adjust the angle of each arm so
the indicators (b) are aligned. This
will place both lamp arms at the
same angle and distance from the
baseboard.
4
Tilt the lamps so that they are
aimed at the baseboard at about a
45 angle (4). Tighten the mount-ing
knobs firmly. The barn doors can be
opened or closed (5) as needed to
illumin-ate subjects of various sizes.
5
Run the lamp cords down the
sides of the lamp arms, and clamp
them at the top and bottom, using
the clips provided (6).
6
Plug the sync cord into the
X-socket on the power supply, and
then into the shutter (7).
The power supply controls (8)
•
Modeling light power switch:
Press 1 to turn on, or 0 to turn off.
This light is used for focusing.
•
Main power switch: Press 1 to turn on,
or 0 to turn off. Light output setting: Al-
lows youto adjust the amount of light
fromthe flash. The output is shown in
watt-seconds. 400 watt-seconds is full
power; 50 watt-seconds is 1/8 power.
•
READY/TEST switch: When the
green light is on, the flash is ready
to fire. Pressing the switch will fire
the flash without exposing the film.
There is a circuit breaker on the
bottom of the power supply. Turn off the
power before re-setting. If the breaker
trips repeatedly, contact an Authorized
Service Center for assistance.
Check that the power supply is turned
off, then plug the power cord into a
black outlet on the baseboard; use the
black switch to turn the outlet on and off
(9) 11O-12OV system;
(IO) 220-240V system.
ALWAYS TURN OFF POWER WHEN
SYSTEM IS NOT IN USE. IF SYSTEM
WILL NOT BE USED FOR EXTENDED
PERIOD OF TIME, UNPLUG POWER
CORD FROM ELECTRICAL OUTLET.
GRASP PLUG NOT CORD AND PULL
TO DISCONNECT.
English
2
Advertisement
