Advertisement
Attach the lamp arms
The two lamp arms are fastened to the
left and right sides of the baseboard,
near the rear edge of the baseboard.
1
Orient the lamp arms so the screw faces
up (33), and the angle indicator faces
the front of the baseboard (34).
2
Insert the screws into the top twoholes
in the metal plate, then tighten them
firmly (35).
3
Orient the horizontal cross bars as
shown (36). With the MP 4+ Standard
Model, note that distance
shorter than distance (v).
4
Attach the cross bars: Slide the cross
bars into the top of each lamp arm (37).
Rotate the bar until the groove
points down and the second groove
is aligned with the fastening screw.
Tighten the fastening screw to lock the
bar in place.
5
Angle the lamp arms: Angle them as
indicated by the two marks, and lock
them in position with the lever. This will
place the lamps in the correct position
for most general copying work. For spe-
cial lighting requirements, the lamp arms
may be angled in any way desired.
The lamp arms are designed for use
with various types of lighting equipment;
see the instructions packaged with your
lights for details on locating the lamps
on the cross bars.
Attach the timer
The timer may be attached to any con-
venient location, such as the front of the
sliding head (38). Simply remove the
paper backing from the adhesive strip
on the back of the timer, and press it
into position.
teries; if the timer stops working, or if the
display or tones fade, the batteries
should be replaced.
open (39), and insert the new batteries
in the orientation (+/-) indicated inside
the compartment.
(u)
is slightly
Important: After replacing the
batteries, press the SET and START
buttons simultaneously, to ensure
proper functioning of the timer.
(w)
(x)
Assembly 6
The timer is powered by two bat-
To replace the batteries, slide the door
Advertisement
