Water Sensor Removal And Installation; Fuel Heater Connector Removal And Installation - Ford 7.3 DIT Power Stroke Service Manual

7. 3L DIT ANTHOLOGY
Pra January 1998
Fual Filtar Sarvh:a
Watu Saa .. r Ra•nal •••
••••• u.u ••
• Disconnect the one wire connector.
• Use a 9/16' wrench and remove sensor.
• To reinstall reverse steps and torque
to
18-241bf/ln (2- 2.7 Nm)
Pual Haatu Cannaclu R•••••l
••• lnalallatian
Note:
W-
sensor
must be removed
before removing
fuel
heater connector.
• [)jsoonnect
the
external one wire
connector.
• Rotate the fuel healer connector clOCkwise
until II clears the lOCking tab.
• Pull connector out and disconnect the
Internal one wire connector.
• To reinstall reverse steps
38