JVC DOME TYPE CAMERA TK-C676 Instructions Manual page 25

Item
ExDR LEVEL This function sets which section of the object is to be displayed in the easiest-to-
view brightness level in the ExDR mode.
To make a low-light section of the object easy to view: Increase the level.
To make a highlighted section of the object easy to view: Decrease the level.
Setting values: –5 to NORMAL to 5
MEMO
●
When the difference in brightness between objects is large, the picture may not change
even when the ExDR LEVEL is varied. This is due to the characteristics of the camera
and is not a malfunction.
●
When the item "SHUTTER" is set to 1/250 or higher, "---" is displayed and the settings to
the item "ExDR LEVEL" cannot be carried out.
●
When the item "ExDR MODE" is set to OFF, the settings for the item "ExDR LEVEL"
cannot be varied.
B&W/COLOUR This function sets the color modes to color or B&W.
MODE ...
When switching the mode between "color" and "B&W" is carried out, the focus may
be dislocated. In such a case adjust the focus again.
B&W Switches the mode from color to B&W and vice-versa.
OFF
ON
AUTO
ALARM IN 1 to 4 : The camera switches to B&W mode when there is an alarm
MEMO
●
To ensure switching between the color and B&W modes:
Setting item "B&W" to AUTO allows the color and B&W modes to be switched according
to the brightness of the object. However, this switching may sometimes not occur de-
pending on the lighting condition and viewing angle.
To ensure the switching, it is recommended to connect the signal from an external sen-
sor (to be purchased separately by the user) to one of the ALARM input terminals of the
camera and perform switching according to the sensor signal.
●
In order to prevent hunting do not set the item "B&W" to AUTO when using an infrared
lamp.
LEVEL When the "B&W" function is set to "AUTO", this function sets the signal level of the
object at which the camera will automatically switch to B&W mode.
LOW
NORMAL : The camera switches to B&W mode when the signal level of the object
HIGH
MEMO
When the item "B/W" is set to other than AUTO, "---" is displayed and the settings to the item
"LEVEL" cannot be varied.
LIGHT TYPE Use this function to set the type of light illuminating the object in the B&W mode.
NORMAL : Setting for normal lighting.
IR
MEMO
If the IR setting is used under ordinary sunlight or fluorescent light, the switching between
the color and B&W modes will not be performed correctly.
Function & Setting
: Turns the B&W mode switching function off.
: Sets the camera permanently to B&W mode.
: The camera automatically switches to Color mode when the ob-
ject is bright and to B&W mode when it is dark.
input from terminals Alarm 1 to Alarm 4.
The B&W mode is set to ON when the contact is shorted (makes
contact) and OFF when the contact is opened (breaks contact).
: The camera switches to B&W mode when the signal level of the object
is low.
is normal.
: The camera switches to B&W mode when the signal level of the object
is high.
: Setting for using IR lighting.
Initial Value
NORMAL
OFF
NORMAL
NORMAL
E-25