Removing A Ceiling Flush Mount Bracket (Optional Wb-S575) - JVC DOME TYPE CAMERA TK-C676 Instructions Manual

Other

Removing a Ceiling Flush Mount Bracket (Optional WB-S575)

3.
4.
Stoppers
5.
Push the stopper release lever
Release
upwards with a screwdriver, etc.
label
6.
E-40
<Check the release labels thoroughly before removal.>
1.
Remove the ceiling panel.
Pull the ceiling panel and disengage the two hooks.
2.
Remove the camera.
Remove the camera from the Ceiling Mount by reversing the at-
taching procedure.
Clamping
bracket
3.
Loosen the clamping screws of the Ceiling Flush
Mount Bracket.
• Loosen the three clamping screws (by turning them counterclock-
wise).
• Make sure that the clamping brackets move inwards.
4.
Lower the Ceiling Flush Mount Bracket until the
stoppers contact the ceiling plate.
*
5.
Push up the stopper release lever, marked (
figure, using a screwdriver.
• While holding the Ceiling Flush Mount Bracket from below so that
it does not drop, push up the one of the three stopper release
levers marked (
• If the ceiling plate is thick and the stoppers cannot be released
easily, push up two of the stopper release levers (including the
one marked (
6.
Pull out the Ceiling Flush Mount Bracket from the
hole in the ceiling.
Tilt the Ceiling Flush Mount Bracket and move it obliquely down-
ward to remove it.
P. 16, "Attaching the Camera"
)using a screwdriver or a similar tool.
*
)).
*
) in the
*