Sample Operation - Electrolux VIVA LOGIC Instruction Manual

SAMPLE INSTALLATION
Notices:
After installation, do not start the washing machine in hurry. First open the tap to let the water press
into the water inlet hose to check whether there is any leakage in the connectors on the both ends. When the
pressure is too high, please shut the tap a little to avoid water leakage.
Step 5: Installation of the drain hose
1. Press the fixing ring with hand to make it loose and
engaged on the drain hose and put the drain hose
into the leading skirt of drain hose in the bottom of
the washing machine to the end at the most (soak the
head of the drain hose in warm water, it will make
the engagement easy), and loose the fixing ring to
let it clasp the drain hose.
2. It had better put the outlet of the drain hose into the nearby drainage permanently, which can save
the trouble that the drain hose has to be connected each time before use. If the drainage is far from the
washing machine, it can be solved by connection of the drain hoses head with end to extend.
Notices: Drain faults will be caused when the drain hose is blocked.
Step 6:Power source and grounding
The washing machine employs alternative current with the rated voltage and frequency. When the
voltage fluctuates between 10% of rated voltage, the washing machine can work normally. A special power
socket for the washing machine had better be set beside the washing machine for convenience and safety.
The method of connection of the socket is as the figure below:
Notices:
The socket and the grounding wire must be installed by an
electrician to prevent incorrect installation or use of the socket,
and to guarantee the safety of use of electricity.
The power wire of the washing machine employs Y
connection and the replacement of the power wire should be
carried out by professionals.
No connection of the grounding wire with the neutral wire,
otherwise the cabinet will be charged, which is likely to cause
the danger of electric shock.
Cabinet
Inner hose
Fixing ring
Drain hose
Leading ring
Grounding wire
Rated voltage ~
SAMPLE INSTALLATION AND SIMPLE OPERATION
Step 7:
Installation of the Rat Mesh
1. Slant the washing machine with angle of 45 in the direction of
the arrows showed in the figure, put the side with the clasper to
the washing machine and the other side to the ground, insert base
cover along the direction of the upper slot of the base from the
back side of the washing machine.
2. Put the base cover straight to the point and then press the base
cover upward till there is a sound of "Gaba" and then screw in
a self-tapping screw(without the self-tapping screw for plastic
cabinet).

Sample Operation

Preparations before using :
1. Lay the drain hose at proper place.
2. Connect the water inlet hose and open the tap.
3. Put the power plug into the socket.
4. Take out the coins and other sundries and shake off the mud and sand on the clothes.
5. Determine water level. Press "Water level" button to select the water level.
6. Press "Power" switch button.
7. Press "Start/Pause" button. The washing machine will go into operation by the automatic program of standard.
Notices:
If you want to set other programs, please see and read "Full automatic program" and "Self-program".
According to your needs, select corresponding programs for your service.
o
Slot
Base cover
Hole for Self-tapping screw