Sample Installation - Electrolux VIVA LOGIC Instruction Manual

NAMES OF PARTS AND SAMPLE INSTALLATION
Names of respective parts
Top Lid
Control
Panel
Base

Sample Installation

Step 1: The washing machine should be placed inside the room with a flat floor, which is convenient
for water supply and drain, has low moisture and no direct sunshine, and does not freeze in
winter.
Step 2: All foam packing (including the fixing frame on the base foam) should be taken off, otherwise
the washing machine will not work.
Step 3: Please adjust the washing machine even according to the instructions below to make the
washing machine run steadily in low noise.
1. Loose the fixing pole on the adjusting foot, screw in or screw out the adjusting foot to
make the four feet placed even on the floor.
2. When the floor is slanting or uneven, it is not easy to make even only by the adjusting
foot. Then the rubber band can be added to the un-flat place.
Inner
Tub
Top
Filter
Frame
Pulsator
Power
Cord
Drain
Hose
Cabinet
SAMPLE INSTALLATION
3. Use a thread tied with bulky objects to be hung on the side face and face side. As the figure: when A=A',
B=B', that is to show that the washing machine is placed flat.
4. After the adjustment the fixing pole should be screwed back and tight.
Notices:
If the washing machine is not placed flat (maximum inclination angle is 2 ), it may cause great vibration or
automatic check and rectification or other abnormal circumstances will often take place in the course of spinning.
All foam packing including the fixing frame on the base foam in the step 2.
Adjustable foot
Loose
Screw in
Fixing pole
Tight
Screw out
Step 4:
Installation of the water inlet hose
1. Check the tap mouth. If it is not even, it can be filed even.
2. Screw loose the locking ring, but do not let the locking ring drop off. Screw the four screws at the same
distance.
3. Put the universal connector into the tap and stick to the tap mouth at the most and then screw in the
screws.
4. Screw tight the locking ring to the right at the most.
5. Pull the skirt of one end of the water inlet hose downwards, and then plug in the universal connector. A
sound of " KA-TA" means proper connection.
6. Grasp the water inlet hose by hand and pull it downward to see whether it is secured.
7. Screw the nut on the other end of the water inlet hose into the water inlet of the washing machine to the
most.
Tap
File
If the calibre of the tap
is big, the connecting
ring can be taken off.
Skirt
o
Base foam Fixing frame
Bukly objects
Locking ring
Connecting ring