T1500 Series Clothes Dryers
6.3
Fault Codes – T1576
Initial Requirements
1. Switch the appliance On.
2. Turn the Selector Knob to the Cotton Extra Dry position.
3. Press the Start Button to begin the program.
4. Note the status of the Anti-Crease LED.
The Anti-Crease LED is lit
The Anti-Crease LED is
Access (Retrieval)
1. Access the Service Mode (6.2)
2. Turn the Selector Knob to Woolens position.
3. Press the Start Button
4. Note the illuminated LED's.
5. Refer to Table 6-3 to determine the stored Fault.
6. Switch the appliance Off.
7. Perform the necessary service steps to rectify the cause of the
fault; proceed to the "Delete a Stored Fault Code" below.
Rotary Iron & Hand Iron
Normal and Rotary Iron
Table 6-3: Fault Code Storage (T1576)
Delete a Stored Fault Code
1. Access the Service Mode (6.2)
2. Turn the Selector Knob to Woolens position.
3. Press the Start Button.
4. Press and hold the Gentle Button.
5. Press the Start button.
6. Release the Gentle button - the appropriate LED turns off.
7. Switch the appliance Off.
STEADY
FLASHING
LED
Lit Steady
Rotary Iron
Hand Iron
Normal
43
Technical Information
No Fault Stored
Fault Stored – Proceed to Access
steps below
Component
Fan NTC open circuit
NTC at heater bank open circuit.
NTC at heater bank short circuit
Fan NTC short circuit
Max drying time exceeded, (180 minutes)