Initial Setup; Channel Summary; Auto Tuner Setup - JVC TM-2001U User Manual

Initial Setup

Auto Tuner Setup

If you have already run the Auto Tuner as part of the quick setup earlier in this guide, please skip
ahead to "Channel Summary" to continue setting up your television.
In Auto Tuner Setup, the TV automatically scans through all available channels, memorizing the active
ones and skipping over blank ones or channels with weak signals. This means when you scan (using the
C +/- buttons) you will receive only clear, active channels.
HANNEL
Press the M button
ENU
œ ❷
To AUTO TUNER SETUP
➛❿
To operate
➛❿¤
To choose CABLE or AIR
œ ❷
To move to START
➛❿
To start Auto Tuner Setup
NOW
PROGRAMMING !
48
Programming will take approximately 1 to 2
minutes.
PROGRAMMING OVER!
• Noise Muting will not work during Auto Tuner Setup.
NOTE:
• Some cable systems experience interference from radio frequencies on cable Channel 95. You
may delete this channel from your scan by removing the "X" next to it on the Channel Summary
screen shown on the next page.
20

Channel Summary

Channel Summary allows you to customize the line-up of channels received by your TV. You can
add or delete channels from the line-up or prevent any unauthorized viewers from watching any or
all 181 channels.
Press the M button
ENU
œ ❷
To CHANNEL SUMMARY
➛❿
To operate
CH ADD CH ADD
:
01
06
:
02 X X
: 07
03
: 08
04 X X
09
:
05 X 10
:
The Channel Summary screen (above) will now be displayed with the channels set to scan marked
with an "X". You can delete channels from the scan by removing the "X". If any channels were
missed during Auto Tuner Setup and you wish to add them, you may by placing an "X" next to the
channel number.
œ ❷
To the ADD column
➛❿
To include or delete from scan
E when finished
XIT
You can block access to a channel by activating the Channel Lock.
œ ❷
To CHANNEL SUMMARY
➛❿
To operate
œ ❷
To the Lock Column
Z to lock or unlock that channel
ERO
E when finished
XIT
Channel Guard Message
When a viewer attempts to watch a guarded channel, the following message appears:
To watch a channel that you have locked, enter the
THIS CHANNEL IS LOCKED BY
Lock Code using the 10 key pad.
CHANNEL GUARD.
If the wrong code is entered, the message "INVALID
PLEASE ENTER LOCK CODE BY
LOCK CODE!" will flash on the screen:
10 KEY PAD TO UNLOCK IT.
The channel cannot be accessed until the correct
NO. - - - -
code is entered.
• Once a channel has been unlocked, it will remain unlocked until the television is turned off.
• See also "Set Lock Code", page 29.
Initial Setup
21