JVC TM-2001U User Manual page 23

BNC connector box
BNC connection box installation
1
I N
O U T
1 Slide the claps on the BNC connector box into the slots at the back of the television
until it clicks into position.
2 Connect the cable out from the bottom of the BNC connector box into the Video Input
jack at the rear of the televition.
3 Use the BNC connectior box as the input jask for the television for any video-in connec-
tions.
TM-2001U
Rear panel
IN
OUT
TM-2701SU
Rear panel
IN
OUT
44
3
V ID E O
IN
L
O U T
A U D IO
R
2
NOTICE
CONNECT THE BNC CONNECTOR
BOX (AUTO TERMINATION). THIS
VIDEO-IN JACK (RCA) IS
NOT
TERMINATED 75
INPUT
NOTICE
CONNECT THE BNC CONNECTOR
BOX (AUTO TERMINATION). THIS
S-VIDEO VIDEO-IN JACK (RCA) IS
NOT
TERMINATED 75
OVER
75
AUDIO OUT (VHF/UHF)
VIDEO
L
L/ MONO
R R
The IN and OUT terminals are bridge-connected.
(When no cable is connected to the OUT terminal, the input signal is automatically
terminated.)
Illustration of TM-2701SU
IN
BNC
Connector
OUT
box
VIDEO
EQUIPMENT
IN
INPUT
S-VIDEO
OVER 75
VIDEO AUDIO OUT (VHF/UHF)
L/ MONO L
R R
1 Connect a white audio cable from the VCR Left Audio output the TV's Left Audio input
jack.
2 Connect the red audio cable from the VCR Right Audio output the TV's Right Audio
input jack.
3 Connect the video cable (BNC) from the VCR output into the input of the BNC connec-
tor box.
4 You can send the video signal from the VCR to another pice of video equipmnt by
plugging a cable into the output jack of the BNC connector box.
Bridge-connection
Video
IDEO
VCR
IN
Yellow
L
L/ MONO
White
Red
IN
R
Audio
45