Safety Information; Important Information - KERN FIS Operating Instruction

When installing the equipment or changing equipment settings, always
carry out a test run with the known test weight at cyclic intervals. This avoids
incorrect results and evaluations.
Ensure that only trained personnel operate and take care of the equipment.
Please check that our products are handled appropriately.
Our products are regularly subjected to further development and are governed by
various regulations specific to the country. Illustrations and graphics used in the
operating instructions may differ from the model supplied.

3.3 Safety information

The equipment may only be opened by trained service engineers in compliance
with KERN directives.
Please disconnect the equipment from the mains before opening.
Warranty is forfeited if the equipment is opened.
The FIS weighing system may not be used in hazardous areas.

3.4 Important information

The measured values are stabilised by a short warm-up period lasting a few
minutes after switching on. Apply the items to be weighed carefully. Do not place
a permanent load on the weighing plate. Be sure to avoid knocks and
overloading in excess of the maximum load (max.), as this can cause damage to
the balance.
Switch the balance off for a short period of time following a disturbance in
programme sequence. The weighing process must now be repeated.
Check the balance regularly using external test weights.
Guarantee/warranty are forfeited if the balance is opened and following use
of the balance outside the prescribed directives.
Keep the packaging in case if should be necessary to return the equipment. Only
use the original packaging to return the equipment.
FIS-BA-e-0512 11