KVH Industries TV3 Installation Manual page 38

B Continued
Configure the IP AutoSwitch
When performing system setup (see
System" on page 24), follow these instructions to
configure the IP AutoSwitch.
NOTE: KVH recommends that you run the Setup
Wizard in the web interface whenever you change
your system's configuration by adding or removing
devices.
a. At the AutoSwitch page of the web interface,
select Add IP AutoSwitch (Figure 1).
b. Enter the serial number and choose a friendly
name for the IP AutoSwitch (for example,
"Salon").
c. Select Save to save changes.
Select a Master Receiver
Any receiver connected to an IP AutoSwitch can
become the master receiver for the system. The
master receiver controls satellite selection.
Important!
The TV-Hub has a built-in IP AutoSwitch. Any
receiver connected directly to the TV-Hub can
therefore be selected as a master receiver
through the web interface.
a. To choose a master receiver, select it on the
home page of the web interface, or press the
Master Select button on the associated
IP AutoSwitch.
b. Verify that the LED in the Master Select
button on the IP AutoSwitch is lit green (see
Figure 2). The LEDs for any other IP
AutoSwitches should be lit orange.
Connecting IP AutoSwitches
Figure 1: Add IP AutoSwitch Screen
"Set Up the
Figure 2: IP AutoSwitch LED Status Indications
LED Color
Orange
Orange,
flashing
Red
Green
Indication
Registered with the system but
not currently the master
Initializing
Error:
• unable to communicate with
the system,
• network is not detected, or
• unable to register
Registered with the system
and currently the master
37