KVH Industries TV3 Installation Manual page 23

15 Continued
Connect Power to the System
NOTE: When powering up a SWM configuration,
apply power to all other system components before
powering up the receivers and DVRs (tuners are
assigned channels during startup).
Follow the steps below to connect power to the
TracVision system (see Figure 36).
IMPORTANT!
All power connections must be hard wired.
a. Make sure that the ground wire from the
TV-Hub has been connected as described on
the previous page.
b. Connect the TV-Hub power cable (supplied
in the kit) to the 10-30 VDC power input on
the rear of the TV-Hub.
c. Connect the black wire on the TV-Hub power
cable to ship's ground.
d. Connect the red wire of the TV-Hub power
cable to the vessel's 10-30 VDC power source.
NOTE: An optional power supply is available
from KVH, part no. 72-0669.
22
Connect Power
Figure 36: TracVision System Power
Power
10-30VDC IN
Filter
Black
Fuse Holder with
Red
9A 32V SFE Fuse