KVH Industries TV3 Installation Manual page 37

B Continued
Wire the IP AutoSwitch
The wiring of the IP AutoSwitch depends on the
specific configuration. Refer to the wiring
diagrams provided in this guide, while following
the general wiring steps below:
a. Disconnect the RF input cable from the
receiver and connect it to the RF In jack on
the IP AutoSwitch. Then tighten the hex nut
to 15 in.-lbs of torque.
b. Connect the supplied 2 ft (60 cm) RF cable
from the To Receiver port on the IP
AutoSwitch to the receiver's satellite input
and tighten the hex nut to 15 in.-lbs of torque.
c. Using the supplied Ethernet cable, connect
the Network port of the IP AutoSwitch to the
onboard network. If a network is not
available, install a router as shown in
Figure 51.
d. If not already connected, connect the TV-Hub
to the onboard network (see Figure 51).
e. Using the supplied Velcro strip, secure the
IP AutoSwitch to the mounting surface.
36
Connecting IP AutoSwitches
Figure 51: IP AutoSwitch Connections
RF Input**
RF In
To Receiver
Satellite In
** Varies depending on your system configuration
* Network Connections
Connect the TV-Hub and IP AutoSwitches to your
onboard network. If you do not have a network, install
a router or router and switch as shown below.
TV-Hub
1
Connect up to 3 IP AutoSwitches
To TV-Hub
1
Network To Network*
IP AutoSwitch
Receiver
AC Power
Router
2 Ethernet 3 4 Internet Reset 12VDC
POWER
AC Power
OR
Router
2 Ethernet 3 4 Internet Reset 12VDC
POWER
AC Power
Connect up to 2 IP AutoSwitches
Switch
8 7 6 5 4 3 2 1
+
POE 48V
AC Power
Connect up to 7 IP AutoSwitches