Sony PMW-EX1R Service Manual page 34

4. Disconnect the harness from the connector
(CN104) on the LED-491 board.
5. Disconnect the fl exible card wire (30 core)
from the connector (CN1) on the DR-644
board.
6. Remove the three screws of b that fi x the
control switch block.
7. Remove the fi ve screws of c and one screw
of d, and disconnect the coaxial cable with
connector from the connector (CN700) on the
DPR-311 board.
8. Remove the handle assembly while pulling
off the fl exible card wire (30 core).
m
. The coaxial cable with connector uses fi ne pitch
coaxial cables. Be careful when arranging the
cable.
. When disconnecting the coaxial cable with
connector, do not attempt to remove by pulling
the cable. Be sure to hold the connector to
remove.
9. Reinstall the handle assembly by reversing
the steps of removal.
2-6 (E)
b
Control switch block
b
b
b : PSW2 x 5 (silver)
c
c
c
Coaxial cable
with connector
DR-644 board
CN1
Flexible card wire
(30 core)
LED-491 board
CN104
Harness
c : P2.6 x 5 (black)
d : M2 x 4 (black)
Handle assembly
c
Flexible card wire
(30 core)
d
DPR-311 board
CN700
PMW-EX1R