1St System Option Code; 2Nd System Option Code - DSC PC560 Installation Manual

[05]

1st System Option Code

When Section [05] is entered, the 4 Zone Lights will be ON or OFF to indicate which options are selected.
To turn a Zone Light ON or OFF, press a number from [1] to [4]. If the light was OFF, it will come ON; if the light
was ON, it will be shut OFF.
LIGHT
[1] ON =
• OFF =
[2] • ON =
OFF =
[3] • ON =
OFF =
[4] • OFF =
• Factory default settings
∗ ∗ ∗ ∗ ∗
If Momentary-contact Keyswitch Arming is selected, the keyswitch must be opened and then closed
to arm or disarm the system. If Maintained-contact Keyswitch Arming is selected, OPEN the key
contact to arm the system, and CLOSE the key contact to disarm the system.
∗∗ ∗∗ ∗∗ ∗∗
∗∗
Turning Zone Light 3 ON programs the KEY Terminal as a Tamper Zone. Refer to the Hook-up Diagram
for wiring instructions.
[06]

2nd System Option Code

Refer to Section [05] for programming information.
LIGHT
[1] ON = Private line
• OFF = 40 BPS 4/2 with Parity
If the communication format is changed: when programming is complete, remove all
power from the system, wait for 10 seconds, and then restore power to the system.
[2] • ON = 1400 Hz Handshake
OFF = 2300 Hz Handshake
[3] ON = DLS Answer enabled
• OFF = DLS Answer disabled
[4] ON = Ringback enabled
• OFF = Ringback disabled
• Factory default settings
If DLS Answer is disabled, the PC560 will not answer calls from a downloading computer.
If DLS Answer is enabled, the system will only connect to the downloading computer using the "double call"
technique. The system must be called by the downloading computer, and the computer must allow the
telephone line to ring only once or twice. After one or two rings, the downloading computer must hang-up the
line and then call the system again within 60 seconds. The system will then answer the second call on the first
ring. Note that the "double call" technique is the only means of connecting to the downloading computer.
If Ringback is enabled, the keypad will sound a series of beeps to acknowledge that communications have been
completed successfully. The beeps will sound after the system has received the kissoff handshake from the
monitoring station's receiver. This is used to indicate to the user that the monitoring station has received
communicated events. NOTE: Do not use the Ringback feature if silent zones are programmed on the system.
14
Momentary-contact Keyswitch Arming
Maintainted-contact Keyswitch Arming
[P] Key: silent alarm
[P] Key: audible alarm
KEY Terminal as Tamper Zone
Keyswitch Operation Enabled
For Future Use
∗ ∗ ∗ ∗ ∗
∗∗ ∗∗ ∗∗ ∗∗
∗∗