Pad Stitching; Edge Joining - Zanussi ZAN2250 User Manual

P AD STITCHING
P AD STITCHING
(1) pattern selection dial: 3
(2) stitch length: 0,5-1
(3) presser foot: zigzag
(4) thread tension disc pressure: 1-4
(5) presser foot presser: 2
EDGE JOINT
EDGE JOINT
(1) pattern selection dial: 10
(2) stitch length: 1-10
(3) presser foot: zigzag
(4) thread tension disc pressure: 4-6
CHAPTER VI MAINT AINANCE OF MACHINE
CHAPTER VI MAINT AINANCE OF MACHINE
Remove the pendular shuttle and its assemblies
Instruction: switch off lamp or pull plug out.Take out the pendular shuttle: Raise
needle to its highest position and lift shuttle Gover. Remove the bobbin case from
the machine, Uncover shuttle lever and draw out the shuffle retaining ring.
Instruction: clean the feed dog with a brush and soft and dry rag
(1) Bobbin case
(3) Shuttle retaining ring
(5) Shuttle carrıer
Installation of the pendular shuttle: hold shuttle center pin and fit carefully black
into the shuttle carrier. Refit shuttle retaining ring and make sure that the following
Center pin is fixed in the Slot of the shuttle canier. Lock retaining ring by turning
levers back into position. Refit bobbin case with bobbin
(6) Center pin
13.09.2006 13:33 Uhr
Adhere tightly the decorative parts to the fabrics or iron it with solvable non-woven textiles.
Stitch around the decorative parts and make sure that suture beyond the decorative parts
should disappear. Insert the needle into the cloth when encountering corner. Raise the
presser foot and pivot the cloth to the left or right.
Instruction: After sewing, adjust the selecıion dial
Fold in both sides with 1.5 cm each and iron it. The folded sides should be fixed to
non-woven textiles with spacing of 0.3 cm. Slowly stitch and make sure that each
stitch should reach the folding edges.
(2) Shuttle lever
(4) Pendular shuttle
(7) Slot
Seite 17
15