Zipper Insertion; Blind Hem - Zanussi ZAN2250 User Manual

ZIPPER SEWING
ZIPPER SEWING
(1) pattern selection dial: 1
(2) stitch length: 1,5-4
(3) presser foot: zipper
(4) thread tension disc pressure: 4-6
BLIND HEMMING
BLIND HEMMING
(1) Pattern selection dial: 5-6
(2) stitch length: 1-3
(3) presser foot: zigzag plus guiding plate
(4) thread tension disc pressure: 4-6
tucks. Pay attention to the tucks, which are to be placed at the side of stopper of guiding plate while sewing.
4. When rıght upper layer of cloth ıs ıroned upward, its stitches are hardly to be perceived.
CHAPTER V DECORA TIVE STITCHING
CHAPTER V DECORA TIVE STITCHING
(1) pattern selection dial: 9
(2) stitch length: 2
(3) presser foot: zigzag
(4) thread tension disc pressure: 6-8
13.09.2006 13:33 Uhr
Stick a zipper or needle it to the fabrics and place it under foot plate.
Draw the thread to be back and lower the presser foot. Sew on the left sıde of
the zıpper by guıdıng the zipper teeth as close as possible to the needle drop.
Fabrics and zipper should be stitched tightly at the same time Pivot fabric to
the opposite side and the way to stitch the other side of zipper should be
identical to that of the left side.
1. Folding method for fabrics (1) Back side of fabrics (2) 0.4-0.7cm
2. Lower presser foot, release the screw of the fixed presser foot and push forward
the guiding plate between the screw and foot plate groove. Fix the screw and make
sure that the stopper of guilding plate should be installed in the middle of foot plate.
3. raisc the presser foot, place fabrics under the foot while keeping tucks facing the
stopper of the guiding plate. Lower the presser foot and stitch slowly in order to
command a better control.The needle on the left zlgzag should be brought just into
Shell stitching
Folded cloth lace should be placed beside the presser foot and needle on the
right of the cloth so as to work out shell stitching.
Seite 15
13