Power Supply; Foot Controller; Sewinglamp; Remove And Attach Presser Foot - Zanussi ZAN2250 User Manual

Anl.790.GB/SE/DK/FI/CZ/HU
POWER SUPPL POWER SUPPL
SEWING LAMP
SEWING LAMP
REMOTE AND
REMOTE AND
13.09.2006 13:32 Uhr
Y Y
It is to be determined that the voltage and frequency indicated on the machine should be
identical to the supply prior to connected to the power.
1.Connect machine plug (5) to, machine interface (4) 2.Connect attaching plug (1) to recacle(3).
3.Switch on sewing lamp with switch button (2).
(1) Attachplug
(3) Receptacle
(5) Machine plug

Foot controller

Foot controller
Foot controller
may change speed of sewing. The tighter the switch is pressed, the faster stitching goes.
Sewing lamp
Sewing lamp hulb stands at the back of top cover.Take the top cover when changing the
bulb (front screw).
! Note
Switch off the power before replacing a bulb.
Take out a bulb:
Hold it and screw off to the left.
Fit over a bulb:
Hold it and screw on to the right.
A TT ACH PRESSER FOOT
A TT ACH PRESSER FOOT
Removing:
Turn forward the balance wheel while raising the needle to the highest position.
Leveling up the presser foot. Hold back the lever on the
foot bearer while releasing the presser foot.
Installing:
Fit over the presser foot so that its plate dowel is just opposite to the groove.
Lower the presser foot lever and its presser foot will be fixed
to the place.
Seite 6
(2) Switchbutton
(4) Machine interface
(6) Foot controller
4