Reconyx Hyperfire Manual page 7

Upload Security Settings from PC to the Camera
Once the SD Card has been programmed using your PC, a file named "Schedule.cfg"
is created inside the "RECONYX" folder on the SD card.
Remove the SD card from your PC and...
1. Be sure your camera is turned "OFF".
2. Insert the SD card into your camera.
3. Flip the power switch to the "ON" position.
When you turn on the camera, the backlit LCD will
display "Reading Card" then "Saved PC Options" as it
uploads the settings to the camera. The Security
Settings information have been read from the SD card
and applied to the camera.
Once this step is complete, the file (Schedule.cfg) is erased from the SD card.
NOTE: The settings will be retained even after the camera is powered OFF.
NOTE: Selecting the "Use Default Settings" option on the camera will restore all
factory settings EXCEPT the cellular settings.
(i.e. email addresses and phone numbers will remain programmed in the
cameras settings until a new configuration file is uploaded to the camera.)
www.reconyx.com 6