Reconyx Hyperfire Manual page 6

Destination Email Addresses:
Up to two email addresses can be programmed into the camera.
Select the appropriate "To" or "BCC" radio button for each entry.
If "BCC" (Blind Carbon Copy) is selected, this will not allow the other email recipients
to see that the camera is sending the photo to the BCC email address.
NOTE: For security reasons, all email addresses must be programmed using the
Security Settings software.
The email addresses are not visible or editable on the camera itself.
When you have finished entering the destination email addresses, press the OK
button. This will save the information to your SD Card.
Error Messages (Optional):
Up to two cell phone numbers can also be programmed into the camera so that if it
cannot send a photo due to poor signal strength, it will attempt to send an SMS text
message letting you know it took a photo but could not send it. Standard text
messaging rates will apply.
Text messages can often be sent even when a picture cannot be sent as a result of a
poor signal. In these cases (where signal strength is marginal), you will at least be
made aware that the camera reacted to a motion event within its field of view and did
record images of the event. All images are still saved to the SD card even if nothing
could be sent.
NOTE: For security reasons, all contacts must be programmed using the
Security Settings software.
The contacts are not visible or editable on the camera itself.
NOTE: A list of all possible error messages that your camera might send you
appears later in this manual.
5
The SMS text message from the camera would read:
"FAILED TO SEND IMG_0002.JPG"
©RECONYX, Inc.