Main Menu - T+A K 6 CV User Manual

A menu control system is used to adjust the tone con-
trols and the surround decoder settings, and also to set
the basic configuration of the K6.
If the TV set connected to the system is switched on, all
the menus are displayed page by page on its screen.
They are also displayed line by line (using English ab-
breviations) on the integral screen of the K6.
Operation:
 
 
Open Main Menu
short
press
   
Select menu point
 
 
  /      
Change menu point
    Activate selection
or
    Leave Main Menu
ProLogic II mode:
This menu point enables you to set the Dolby ProLogic II
decoder to suit varying programme material.
Movie for films
Music for music
Matrix for mono programme material
Note
The unit stores the current ProLogic II mode for each
source and sets this mode again, when the source is
selected next time.
Menu control system

Main Menu

e.g.
pp I pp I I I I I matrx pp I pp I matrx matrx matrx
Select
menu point
Main Menu
Pro Logic II mode Matrix
Balance Left/Right mid
Srnd/Front mid
Tone Treble 00
Bass 00
Tone control off
Subwoofer level 00
Loudness off
Dynamic range maximum
STOP / / / / / OK
The 'Main Menu' contains all the functions required to
operate the K6 in normal daily use. Press the 
button briefly to open this menu.
When you initially install the K6 all the audio and video
components of your surround system must be set up to
suit each other, and the system then has to be adjusted
to suit the acoustic characteristics of your listening room.
All these processes are carried out using the 'Configura-
tion Menu' which is opened by holding the 
ton pressed in for approx. 2 seconds (see 'Configura-
tion Menu').
Explanation:
The 'Main Menu' enables you to change settings of the
K6 which are occasionally required for daily listening.
Press the    button briefly to open the 'Main Menu'. 
All changes take effect immediately.
If the TV set connected to the system is switched on, the
menu appears on the TV screen. At the same time the
integral screen displays the first menu point.
Change
value
Movie Music Matrix
10L 10R
10R 10F
-06 +06
-06 +06
off
on
-10 off
off
on
minimum standard maximum
Balance left/right and surround/front:
These two menu points enable you to adjust the balance
between the left/right and front/surround loudspeakers.
Balance can be altered in 1 dB increments.
10L (left) . . . . . 10R (right)
10R (surround) . . . . . 10F (front)
Mitte (neutral setting)
Note
The purpose of this function is to compensate for a tem-
porary problem, e.g. an unusual listening position, or a
poorly produced recording. The basic settings for loud-
speaker balance which apply to your listening situation
should always be carried out in the 'Loudspeaker Bal-
ance Menu'!
7
  
 but-  
Operation