T+A K 6 CV User Manual page 47

   
FM ANT - aerial input
The K6 features a 75 Ohm VHF aerial input (domestic
aerial or cable).
   
VCR / TV B
Sockets for connecting a video recorder.
Alternatively: connection for a TV set in an adjacent
room.
 
 
MAINS FUSE
It is essential to use a replacement fuse rated exactly as
printed on the case.
 
 
MAINS INPUT
The mains cable is connected to this socket. When con-
necting the unit to the mains it is essential to read and
observe the notes in the sections 'Setting up, using the
K6 for the first time' and 'Safety Notes'.
 
 
STB
(Composite, S-Video, Component)
Sockets for connecting a set-top box (SAT or cable re-
ceiver).
   
TV
(Composite, S-Video, Component)
Input / output sockets for connecting a TV set or monitor.
 
 
AUX AV
(STEREO CINCH and VIDEO)
Input for connecting an additional AV source device.
(Composite, S-Video)
       
A - FRONT
Terminals for front loudspeakers *
     
 
B
Terminals for loudspeakers in adjacent room *
 
 
PRE OUT
(CONTROL)
Connection for   active loudspeakers, to be used as  
front speakers in the main listening room.
Note
This socket also supplies a switching signal which can
be used to activate other devices (e.g. projectors, pro-
jection screens etc.) automatically via the K6 (see 'Ap-
pendix B').
     
 
A - REAR
Terminals for surround loudspeakers *
     
 
A - CENTER
Terminals for center loudspeaker *
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be con-
nected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool such
as a knife blade.
* Notes
The impedance of the loudspeakers connected to the K6
should not be less than 4 Ω Ω Ω Ω (DIN rating).
It is essential to check that the screw terminals are firmly
tightened, and that there are no stray strands of cable
which could cause a short-circuit.
The terminals also feature cross-holes into which standard
insulated 'banana plugs' (4mm) can be fitted from the
underside.
The    accessory range includes a selection of high- 
quality cables which are an exact match to 
ment.
47
 equip-
 
Setting up