T+A K 6 CV User Manual page 16

Renaming a Program
Operation:
With Tuner selected . . .
   
Call up Tuner Menu
press
briefly
 
 
Call up Program Menu
 
 
Confirm selection
Press repeatedly until the
display shown here ap-
   
pears on
screen
Select the Program Num-
 /   
    ber whose name is to be
edited
   
Optional: enter Program
to
Number directly
 
 
   
Activate name input
 /        Change input position
   
Change the letter at the
 
 
input position
Repeat the last two steps until the desired name is dis-
played on the screen, then
Store name and close
 
 
Tuner Menu
or
Leave Tuner Menu with-
   
out storing the name
*) The Tuner Menu and the Program Menu are also
displayed on the screen of a TV set connected to the
system (see illustrations on previous page).
Operation
e.g.
*)
MODE NORM MODE NORM MODE NORM MODE NORM
*)
PROGRAM PROGRAM
PROGRAM PROGRAM
e.g.
P01 105-60 P01 105-60
P01 105-60 P01 105-60
e.g.
the integral
RENAME P01 RENAME P01 RENAME P01 RENAME P01
e.g.
RENAME P05 RENAME P05
RENAME P05 RENAME P05
e.g.
WDR 4 WDR 4 WDR 4 WDR 4
e.g.
_ _ _ _ WDR 4 WDR 4 WDR 4 WDR 4
e.g.
M WDR 4 M WDR 4 M WDR 4 M WDR 4
e.g.
MEINNAME MEINNAME MEINNAME MEINNAME
Explanation:
Not all radio transmitters broadcast the station name, and
in such cases the integral screen displays the tuning indi-
cator and the reception frequency instead of the station
name. Other transmitters broadcast the station name as a
moving script, which is at variance with the RDS norm.
If you wish to display a 'program name' on the integral
screen in such cases, you can use the K6's Rename
function. This process enables you to assign any name to
each Program Number.
First call up the Rename function, then use the 
buttons or the numeric buttons to enter the Program Num-
ber whose name is to be entered or changed.
Press the   button, and you are ready to edit the
 
name.
You will see a flashing pointer, or cursor, on the integral
screen and the screen of a TV set connected to the sys-
tem. This cursor indicates the input position, and you can
move it using the    /      buttons.
Use the   and      buttons to change the letters at the 
input position.
You can now enter the name of your choice, between one
and eight letters in length. The new name is stored when
you press the   button.
 
Note
A name you choose yourself takes priority over the RDS
station name which the radio transmitter broadcasts, i.e. it
not over-written by the RDS name. If you wish to erase
your selected name you must clear the Program Number
and store the program again under the same Program
Number.
16
 /      