T+A K 6 CV User Manual page 57

Always disconnect the unit from the mains supply before
cleaning it. The surfaces of the case should be wiped
clean with a soft, dry cloth only. Never use abrasive or
solvent-based cleaners! Before switching the unit on
Switching the remote control address
Switching the K6
If the K6 responds to the remote control commands in-
tended for another piece of equipment (TV or video re-
corder),it can be switched to an alternative remote control
address. This is the procedure:
Switch the K6 off, and then on again. Immediately after
switching on, press the left-hand select button under
the machine's front panel, and hold it pressed in until a
running script appears on the integral screen.

Select
button
Release the switch, and hold the left select button
pressed in again until the K6 switches to the next remote
control address. The message on the integral screen
('RC-ADR 1' or 'RC-ADR 2') tells you the address
(RC-ADR) to which the K6 has now switched.
To open the
battery com-
partment
disconnect
the latch by
pressing in,
then lift the
cover out.
Remove the
old cells and fit three new dry cells of the LR 03 (MICRO)
type in the battery compartment, taking care to fit them
with correct polarity. Please remember that all the cells
must be replaced at the same time.
Care of the K6
 
Change
buttons
Changing the batteries
again check carefully that no short-circuits exist at the
terminals, and that you have not disturbed any connec-
tions.
Switching the remote control address
Now you must set up the address of the F6 RC handset
to match the K6:
Hold the   button and the numeric button 
 
pressed in simultaneously. After about 10 seconds the
LED will flash. Now press the numeric button 
  .  
Pressing the numeric button 
control system to the
( RC-ADR 1 ), whereas button 
tive address ( RC-ADR 2 ). The LED goes out to confirm
that you have switched the setting..
Note
If you have already re-set the remote control system to
Address 2 (see above), you will need to repeat the
change procedure after fitting new batteries.
Disposing of exhausted batteries
Exhausted batteries must never be thrown into the
household waste! They should be returned to the battery
vendor (specialist dealer) or your local toxic waste
collection point, so that they can be recycled or disposed
in a proper way. Most local authorities provide collection
centres for such waste, and some provide pick-up
vehicles for old batteries.
57

 
 or
 
 sets the remote
 
standard RC address
 sets the alterna-
 
Setting up