Specifications; Receiver; Operation Panel; Power Supply - JRC NCR-333 Instruction Manual

9.1 NAVTEX RECEIVER (NCR-333)

9.1.1 Receiver

(1) Receiving frequency
(2) Receiving modulation
(3) Sensitivity
(4) Antenna input

9.1.2 Operation panel

(1) Type of display
(2) Key board
(3) Back-light
(4) Dimmer control

9.1.3 Power supply

(1) Input voltage
(2) Power consumption

9.1.4 External interfaces

(1) INS (Integrated Navigation System) communication ports DATA IN / DATA OUT
One communication port meets the requirements of IEC 61162-1
- Baudrate
- Data bit
- Parity
- Stop bit
- Flow control
(2) External printer / maintenance port PRINTER/MAINTENANCE
One communication port meets the requirements of RS-232C (D-sub 9pin).
- Baud rate
- Data bit
- Parity
- Stop bit
- Flow control
(3) Remote maintenance data output port DATA OUT2
One output port meets the requirements of IEC 61162-1
(4) Photo mos relay terminals EXT ALM
One port for external alarm device
(5) Photo coupler terminals BK
One port for 12VDC or 24VDC
(6) MPD (Multi purpose display) communication port DISP
One communication port meets the requirements of RS-485

9. SPECIFICATIONS

: 518kHz, 490kHz and 4209.5kHz
: F1B
: CER ≦ 1x10
: 50 ohms for NAVTEX antenna
50 ohms for wide-band antenna
High impedance for wire antenna
: 5.7-inch FSTN LCD, 320×240 dots
: 12 keys
: For LCD and key board
: Bright, medium1, medium2, off (Selectable from keyboard)
: 12 / 24Vdc (+30%, -10%)
: 9 W (at 24 Vdc input)
: 4800bps
: 8bits
: none
: 1bit
: none
: User setting (4800 / 9600 / 38.4k bps)
: 8bits
: none
: 1bit
: User setting (Hard / None)
-2
at 1uV (CER: Character Error Rate)
9-1