Table of Contents
Advertisement
NOTE:
* Do not depress the brake lever when
the wheel is off the motorcycle. The
caliper piston will be forced out of the
cy[nder with subsequent loss of brake
fluid. If this occu$, seryicing of the
blake system will be necessary. See
your authorized Honda dealer.
Installation
1. Lower the forks lightty so that the
hollows in the fork legs rest on top of
the axle.
CAUTION :
Ilhen itstallilg
the v)heel, fit the brake
disc (7) carcfu Y betweet the brake
pads to avoid damuging the Pads,
2. Install the axle holdeis (5) with the
"F" arrow forward and hand tighten
the hold€r nuts (4) with flat washers
and lock washers. Make sure the rpeed-
ometer cable gea! box is hodzontal.
3. Fit the brake caliper ov€r
insta.ll the caliper bolts (3), and
them to 3-4 kg-m (22-29 ft-lbs)
4. Tighten the axle holder nuts (4)
left axle holder (speedometer
side) to 3-4
ke-m (22-29
torque, stafing with the
5. Measure the clearance
outside surface of the dght
(7) and the rear of the caliper
(6) with a 0,7 mm (0.028
(6)Caliper holder
(7)Disc
Advertisement
Table of Contents
