Advertisement
i.
the same time the sine wave observrd c
the oscilloscope is not clipped.
With the Oscilloscap* connected across tl
load resistor, cbrerve that the 700OHz cir
wave is not clipped or unu$Ially distarted ;
bsth low and high vtrfunre. If necessar
make additional minsr adjustments.
When a clean, undistorted sine waye at mar
murn voltage is achieved, the alignment
complete.
Secure the adiustment screw, and appty
drop cf lock-tight sealer.
Check the sound with a well recarded scur
track.
On NST & NT-3 models, make a recordir
and re-check the playback.
k.
m .
n-
NOTE (1): $hould the record not function, ref(
to the arnplifier section 314-4-2 an
check amplifier Gr bias oscillator funr
tions.
NOTE (2): Excessive asdio hum may occur b
installing a motor without its magneti
shield.
b . y
Advertisement
