Advertisement
SYMPTOM
TMECHANTCAL
.PROBAELE
CAUSE
the
'1.
Reverse clutch cover pulley
REMEDY
l. Che ck & ad just; or replace-
{See Sec 5-3}
2- Check & adjust.
{See Sec 5-1 }
3. Cbeck & reposition, or re-
place. {See Sec 5-1}
4. Check & adjust
l. Check & clean, or adjust-
{See Sec 5-3}
2- Cheek & reposition
(See Sec 5-1 )
S.Check & replaee
27. Weak back
supply rsel in
te nsion of
"forward"
binding and clutch cam is not
releasing, or clutch caver
pulley defective
28- Weak back tension of the
take-up reel in l'revgrse"
?9. Loop lsstter roller sontinr,res
to activate, or activates er-
ratically in "forward"
?. Clutch cover pulley has nc
end play on the #'l sprocket
drum shaft.
3. Clutch cam seated ineorrect,
or defective
4. Clutch cam binding between
clutch
coyer pulfey and
spacer
1. Drive gear is binding, or has
no end play on the drive
pullby shaft.
2- Clutch cam seated incorrect,
or binding betwcen drive gear
and clutch cov€r assy, or
defective clutch cam
3- Drive gedr, ar clutch cover
defective
1. Damaged or paar film
2. Insufficient gear spring ten-
sion
r
3. Loop setterl roller in the
wrong position-
4. #2sprocket plate loose
5'. Lower loop is toc'small
6. Insufficient claw protrusion,
or claw pitch.
7- Broken claw
8. Too much take-up tension
9. Incorrect cldarance between
the laop setter gear and main
drive belt
10. Loop setter gear, or main
drive belt defective, or broken
1 I . Insufficient tension of the
film shae springs
1. Repair.cr repface
2. Stretch or replace
{See 5ec 5-4-B}
3. Relosate & ehdck
{See Sec 54}.
4. Check & {ghte;n
5. Check #2.sp1o.1r*t timing
{See Sec 54-B).
6. Check
{See Sec 4-1-DI }
7- Cheek & replaee
8- Check & lubricate take-up
spindle cork
{See Sec 5-1 }
9. Adiusl clearance
(See Sec 5-41
10- Replace
11. Stretch or replace.
- 8 -
Advertisement
