Help And Tips - Beko 32" User Manual

10

Help and tips

Failure
The television does not function
Poor picture quality
Shadow and reflection in the
picture.
No picture
No color.
No or defective teletext
No sound
Remote control does not work
Picture is not readable after
turning on the TV
If your television does not work properly even though you tried the above mentioned solutions, try turning
it on and off again. If you cannot start your television even though you have applied all noted methods,
refer to the dealer or authorised service from where you purchased the product. Never attempt to repair a
faulty device yourself.
Possible cause
Is the power cord connected to the
mains supply?
Is the main power On/Off button on?
Is the antenna cable attached?
If you are using a satellite antenna, is it
well adjusted?
Antenna may be affected by two
connected external devices.
It may need fine tuning.
Picture settings are not correct.
Channel setting
Antenna
Is there any damage on the antenna
cable?
Are you sure you pressed the correct
button on your remote control?
Color intensity level is at the lowest
setting.
Broadcast system setting (if setting
choice is available)
Problem in channel broadcasting.
Television channel (no teletext) or
antenna system.
Very weak signal
Temporary sound mute may be on
Is the sound turned down?
Are the batteries correctly placed?
Are batteries exhausted?
Is there any obstacle between the
remote control and television?
Child lock is active.
26 I
Solution
Check the power cord.
Check if the On/Off button is on.
Check the antenna cable.
Have the antenna adjusted.
Try disconnecting one of the devices.
Perform fine tuning.
Adjust Brightness, Contrast and Color.
Perform automatic, manual channel
setting or fine tuning.
Check antenna cable and system
Check the antenna cable.
Press the PR+ or PR- button to turn on
the TV.
Lighten the color.
Select the broadcast system.
Test with another channel.
Test another channel for fine tuning and
shadowy pictures
Check the antenna system.
Try pressing the mute button
Turn on the volume with Vol + button.
Place the batteries correctly.
Replace the batteries with new ones.
If yes, remove it.
Disable the child lock.
EN