Start; Antenna Connection; Powering On Your Device And The Initial Use; Batteries - Beko 32" User Manual

Start

4
Remove your television carefully from its box. You
can keep the packaging of your television to use
in future.
Contents of the box
Power cable (*)
Adaptor (*)
Remote control

2 batteries

Note:The Scart, VGA (*) and RCA cables are not
supplied with the device.
(*) These features are optional and may not be
available on all models.

4.1-Antenna connection

If you use a 75 Ohm coaxial cable (round cable)
as an antenna cable, connect the antenna plug
directly to the antenna input located on the TV.
Motorized vehicles, energy lines and
telecommunication lines affect your antenna.
Therefore, be careful to install your antenna away
from these and metal surface in such a way that it
shall not swing. Do not make your antenna cable
longer than required and do not coil it. Make sure
that it is not crimped passing through a window or
door. Your antenna and cable might be affected
by natural phenomena such as rain, wind, smoke
and humidity over time. Periodically check your
antenna and equipment.
4.2-Powering on your device
and the initial use
1. Insert the power cable or the adaptor into the
appropriate power supply input located on the
back panel of the LCD TV.
2. Insert the plug of the power cable or adaptor,
supplied with the device into the mains socket.
or
Note 1: Your TV will switch to the stand-by mode
in five minutes if there is no broadcast signal from
antenna.
3. Press the power on/off button located
on the LCD TV.
POWER
4. To power on your television, press
any numerical key or POWER, PR+ or
PR- keys on the remote control. For this
process, you can also use the buttons
on your TV. The picture will appear on
the screen after a short while.
Note: If you are not going to use your television
for a long time, unplug its power cable from the
socket.
Initial power on and performing
settings
To set up your television, read the sections on the
TV controls and making the channel settings.
4.3-Batteries
Open the lid of the battery compartment and make
sure that you have placed the batteries in the
correct direction. For this remote control, UM-4,
IEC R03 or AAA 1.5 V batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for this
purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will be
reduced at a distance of 8 meters from or at an
angle of 30 degrees beyond the centre of the TV.
6 I
EN