4-4.Positioning The Appliance; 4-5.Leveling The Appliance; 4-6.Cold Water Connection; 4-7.Drain Hose Connection - Haier DW12-TFE3 Series Service Manual

Service Manual
Issue
Model No.DW12-TFE3 Series
Rev.

4-4.Positioning the appliance

Positioning the appliance in the desired location. The back should rest against the wall behind it,
and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to facilitate proper installation.

4-5.Leveling the appliance

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the
dishwasher, making it level. In any case, the appliance should not be inclined more than 2°. If the
appliance is level, it will help ensure proper performance.

4-6.Cold water connection

Connect the water supply hose to a threaded 3/4 (gas) connector,
making sure that it is fastened tightly in place (see fig.A).
Some models are fitted with an "Aquastop" water supply hose (see fig.B)
in which the small filter is already housed in the threaded end.
fig.A
If the water pipes are new or have not been used for an extended period
of time, let the water run to make sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water inlet can get blocked and damage the
appliance.
fig.B
Warning
The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be reused.

4-7.Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink,
making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a
connecting piece for the drain hose (fig.C). The free end of the hose must be at a height between
40 and 100 cm and must not be immersed in water.
8